Grass-valley 7600REF Manuel d'utilisateur télécharger pdf (Page 19)

7600 SD/HD/MHD-REF — Instruction Manual 19

Installation

Follow the instructions below to unpack, install, and cable the 7600REF

frame.

Unpacking

Carefully unpack the unit from its packing box and check for signs of

damage. Check the contents of the box against the packing list and your

original order to ensure that you have received the correct parts.

In the event the unit has been damaged or does not match your order,

contact the Thomson Grass Valley Sales office listed on Contacting Grass

Valley on page 4.

Module/Software Installation

All hardware modules are installed at the factory and shipped inside the

unit. Module functionality included in the model configuration depends

on the model type (see

7600REF Models on page 18). Any software function-

ality included with the model is already installed and enabled.

Rack Mounting

The 1 RU rack frame has integral rack mounting ears on the frame front

cover for direct mounting into a standard 19 inch rack. Carefully place the

unit in your rack and firmly attach it to the rack using four standard rack

screws (not provided).

CAUTION This unit has air intakes on one side of the unit and fan-assisted exhaust vents

on the other side of the unit. Ensure that these have an unobstructed air flow,

otherwise the unit will overheat. Pay particular attention to ensure that any

rack wiring or cable trays do not obstruct the vent. 60 mm (2.36 in.) of clear

space should be allowed between the vents and any potential obstruction.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 83 84

Pas de commentaire

Grass-valley 7600REF Manuel d'utilisateur Page 19