Grass-valley 7600REF Manuel d'utilisateur Page 20
- Page / 84
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
20 7600 SD/HD/MHD-REF — Instruction Manual
Installation
Rear Panel Connections
The rear connectors for the 7600REF frame are shown in Figure 1. Presence
of hardware and software functionality depends on the model you have
purchased (see
7600REF Models on page 18). Cabling instructions for each
of the connectors are explained in detail in this section.
Figure 1. 7600REF Rear Backplane
Grounding Lug
The unit is provided with a single 4 mm (0.16 in.) ground lug on the far left
of the rear panel. Incoming mains ground from the IEC connector is inter
-
nally bonded to both the chassis and technical 0V to meet safety require-
ments and performance specifications. The stud allows the addition of an
ground strap, if required, for rack installations.
Ethernet Port
Each 7600REF model is equipped with a 10/100 base-T Ethernet port. This
port may be configured for either dynamic (DHCP) address mode or static
address mode. Configuration is done in the Setup menu (see
Setup Menu on
page 47). The 7600REF should be connected to the network in the same way
as other networked devices (such as a computer or printer) with a 1:1 CAT 5
RJ-45 cable.
Tri-Level Sync Reference (7600 HD-REF and MHD-REF Models)
The TRI-LEVEL SYNC REFERENCE BNCs will output four independently
configured tri-level sync outputs. Setup is done in the Options menu (
HD
Tri-Level Sync (7600 HD-REF and 7600 MHD-REF Models) on page 69).
HD/SD SDI Test Outputs
The outputs from the SD/HD SDI TEST BNCs 1, 2, and 3, provide three
independently configured test signals. If the HD video capability is
present, further HD video formats are available. The three outputs are con
-
figured in the Digital Video menu (Digital Video Menu on page 33).
90-260V
2A-1A
AES
AES 1
432 1 4 32 1
32 1
54321
AES 2GPS 1 PPS
10/27/WC OUT
ANALOG AUDIO/REMOTES
ETHERNET
5/10 REF IN
LTC
90-260V
2A-1A
47-63Hz
AC ONLY
47-63Hz
AC ONLY
LOOP
GENLOCK
TEST
BB/ANALOG
TEST
SIGNALS
SD/HD SDI
TRI-
LEVEL SYNC
Grounding Lug Tri-level Sync Outputs
SD/HD SDI Outputs
Ethernet Port Analog Audio and Remote Control
Analog BB Reference/Test Outputs
AES Audio Out (Balanced)
10/27/WC Out
GPS Option/AES Unbalanced Audio
Genlock Loop input
5/10 Ref In
LTC Out
AC/Mains InAC/Mains In
- 7600 SD/HD/MHD-REF 1
- CERTIFICATE 2
- Contacting Grass Valley 4
- Contents 5
- About This Manual 7
- Safety Summary 9
- Warnings 10
- Cautions 11
- Regulatory Notices 13
- Canadian Certified AC Adapter 14
- Certifications 14
- 7600 SD-/HD-/MHD-REF 17
- Reference Generator 17
- 7600REF Models 18
- Installation 19
- Rear Panel Connections 20
- Analog Audio/Remotes 21
- GPI Inputs 1 and 2 22
- GPI Outputs 1 and 2 23
- D-9 Female 24
- Power Supply Replacement 26
- Operation 27
- Selecting a Function 28
- Changing Values 29
- Leaving the Selected Function 29
- Menu Timeout 30
- Front Panel Lock 30
- Figure 5. Top Level Menu 31
- Digital Video Menu 31
- Analog Video Menu 31
- Audio Menu 31
- Lock Mode Menu 31
- Setup Menu 32
- Status Menu 32
- Options Menu 32
- Digital Video – Test Patterns 34
- Digital Video – Timing 35
- Digital Video – AES 35
- Digital Video – EDH 36
- Figure 11 37
- Figure 12 38
- Analog Video – YUV 39
- Analog Video – RGB 40
- Analog Video – YC/BB 40
- Audio – AES 1 and AES 2 42
- Figure 17. AES 1 Menu 42
- Audio – Analog 43
- Figure 18. Analog Audio Menu 43
- Genlock – Mode 45
- Genlock Loss 45
- Genlock – Field Lock 46
- Genlock – Input Standard 46
- Setup – GPI Control 48
- Figure 21. GPIO Menu 48
- Setup – More 49
- Figure 22. Setup More Menu 49
- Setup – Comms 50
- Figure 23. Comms Menu 50
- Figure 24. Status Menu 51
- Option Menus 52
- GPS Antenna Requirements 53
- Disclaimer 53
- Acquisition Process 54
- GPS Menu Structure 55
- Figure 27. GPS Control.Menu 56
- Figure 28. GPS Status Menu 57
- •JAM Mode 58
- . Timecode 59
- Figure 29. Setup –LTC Menu 60
- LTC – Frame Rate Sub Menu 61
- LTC – Binary Group Sub Menu 62
- VITC Within Analog Waveform 63
- Figure 33. VITC Menu 64
- Figure 34. VITC Menu 65
- Figure 35. VITC – Line Menu 66
- Figure 37. SDI ATC Menu 67
- Using a TFTP Server 70
- Preparing a TFTP Server 71
- Preparing the 7600REF 72
- Updating 7600 Software 73
- Specifications 74
- 0 ± 0.5V 74
Produits connexes et manuels pour Équipement Grass-valley 7600REF
(18 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.428 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels